How difficult is it to change oil coolant lines in a 2000 chevy blazer?

on a difficulty level of 1-10 its about a 4,the main thing you have to be careful of is the o-rings,make sure they don't get pinched,other than that ,if you have the right tools it can be done in about 30-45 minutes,id also recommend that you change the oil when you do this,its not a bad job if you can get to it,this is done best by getting it on a set of car ramps,good luck with it,and be careful.How difficult is it to change oil coolant lines in a 2000 chevy blazer?thank you.

Report Abuse

How difficult is it to change oil coolant lines in a 2000 chevy blazer?oil coolant lines do you mean the tranny lines.How difficult is it to change oil coolant lines in a 2000 chevy blazer?not to bad.you do have to raise the engine slightly to get the lines to clear the front axle thou.How difficult is it to change oil coolant lines in a 2000 chevy blazer?it isn't very hard at all but some good advise remove the oil filter base adapter when removing the cooler lines be sure to let it drain after it has been removed to help keep the size of the mess at a minimum be sure to replace the receiver o rings when you reinstall the system and also make sure the heat wrap is also on the cooler lines when reinstalled this is a must and will most defiantly safe the life of the new lines .....good luckHow difficult is it to change oil coolant lines in a 2000 chevy blazer?this isnt to hard to do just dont loose o rings mayne techs raising motor to get lines over front sxle but you dont have to just use your brain alittle put bar along motor wiggle motor a little and pull and guess what oil lines are out shouldnt take 1/2 hr the inexperienced about a hour.did it all the time.showed other techs this same proceedure and they to are amazed. now the hole shop does it that way